Tough Coat is perfect for those high traffic surfaces such as table tops, our non-yellowing water-based wipe on sealer which pairs perfectly with Fusion Mineral Paint giving extra protection but with the same matte finish.
Shake gently before use. If applying to a recently painted surface, allow 12-24 hours of drying time before applying.
For best results, use with a damp lint free rag and apply two coats 2-4 hours apart.
In humid conditions longer drying times may be required.
Be sure to gently mix your Tough Coat™ prior to using it as the matting agent and other ingredients may settle to the bottom.
Do not shake vigorously as this will cause air bubbles in your piece that are difficult to remove once applied.
GOOD TO KNOW:
500ml covers about 75 sq.ft (7m2). Always test your methods and process to ensure best results. Clean up is easy with soap and warm water.
NOTE: FusionTough Coatmay appear milky when applied overdarkFusion Mineral Paintcolours, such as CoalBlack, Ash, Chocolate and Midnight Blue. I recommend using a Satin Top Coat like General Finishes High Performance to avoid this should it happen or you can try adding small amount of the paint colour to the Tough Coat alternatively which may give a better effect.